Pete, the just one pictured is actually mine. I in no way obtained it to operate over a 744. The scale of the highest rib ended up just far too distinctive in the 715 shroud it truly is mounted on at the moment.

Does any person have any information on achievable dates or some other information on these. It took eternally to discover a single these in the correct problem.

I received very tired of dropping the cylinder prevent on my initial 15-two and inevitably bought six on the substitution cylinder stops. Easier to put in a different one than search inside the mud and crud on range to find a missing cylinder prevent.

An oldie but agoodie– The first Holden Ironsighter see-by way of scope method. These were being utilised on all sorts of guns and were being properly produced. Scope sits a little bit high with them.

Sometimes this intended changing what was Beforehand thought to be "correct". And Indeed, some submissions were not involved mainly because they just didn't slot in any reasonable way.

Seriously instructive and also a great deal appreciated. Clears up loads of questions for me and hopefully others.

This is another, quite possibly the rarest considered one of all, the EWK Clamp Mount w/picatinny rail. It appears to be like slightly funky Along with the very long rail beneath a Fastfire.

And early Dan Wesson revolvers Have got a cylinder catch bump-halt pressed in to the facet plate. This bump within the aspect plate, retains the cylinder from falling off when It is open up.

The CZ/DW mount only goes in the shroud. I have a new a person in dan wesson custom barrel Blue that i'm not utilizing; in fact, I may very well be in the marketplace for a SS 1 if any one is keen on a swap.

It's all a little complicated and I hope that you just or among the list of other experts on this fantastic Discussion board may also help me.

The crane (and cylinder) on non-porkchops is held in the frame with the crane lock (part 42). Porkchops do not have that as the flange on the porkchop barrel keeps the crane in position during the frame.

My plan for sometime is always to update and insert to my primary listing with newer entries as they seem to fit in, AND modify the initial listing if newer entries challenge many of what was Earlier regarded as correct. You can find serious chances for me to include to your (not lots of) 1911 entries that I've.

My brother picked up a sweet model fifteen porkchop a couple many years back and under no circumstances shot it. The dude he bought it from. Said that it absolutely was missing the cylinder lock.

Then you'll find mounts I am unable to discover… They're rib clamps similiar to the Leupolds. Millett also manufactured mounts similiar.